124 KAYENNE — User Manual
Section 3 — System Operation
Default Keyframe
Default Keyframe settings are applied when an empty register is recalled
and when the
CWB (Clear Working Buffer) button is pressed in the Master
E-MEM Module (
EMEM Edit, CWB button) of the Control Panel.
• SPOP clears the working buffer of enabled levels to Default Keyframe,
however it does not clear the source memory.
•
DPOP clears the working buffer of enabled levels to Default Keyframe
and clears the source memory to the default settings for sources
selected on enabled levels.
The Default Keyframe menu is used to learn the current Kayenne panel
state to the system’s Default Keyframe (and to set the Default Keyframe
back to factory settings). Individual settings for each MEs are stored in the
Default Keyframe, so different states can be saved for different MEs, if
desired.
Note Individual Default Keyframe settings are saved for each Kayenne ME.
The Default Keyframe menu is accessed by touching User Setups, Suite Prefs,
Default Keyframe (Figure 91).
Figure 91. Default Keyframe Menu
To Next Page
Loading...
