126 KAYENNE — User Manual
Section 3 — System Operation
Table 5 shows the source to button mapping for the 1st (unshifted) and
second levels for a 25 button 2ME system.
Table 6 shows the source to button mapping for the 3rd and 4th levels for a
25 button 2ME system.
Note When you map a Shift or DELG button, that button will be mapped in the
same location across all Shift Levels.
If a Kayenne system’s NV memory is cleared, local panel button mappings
will revert to the factory defaults shown above.
Source Button Mapping
On the Kayenne system, each bank on the Control Panel (Source Modules
and Local Aux Module) can have its own independent source-to-button
mapping, if desired, as well as each Remote Aux Panel. Typically button
mappings on the Control Panel are set the same, for operating simplicity.
However, in some situations individual bank mapping can be advanta
-
geous. For example, on a show with a large number of sources you can
place all the DDR and VTR sources on one bank, all the cameras on another
bank, etc., and then have direct access to any desired source. If you use this
Button 33,34 Shift, Shift Shift, Shift
Button 35 Delegate Delegate
Table 5. 2-ME/25 Factory Configured Source to Button Mapping 1st and 2nd Levels
Panel Button (25)
1st
(Unshifted)
2nd
Button 1 Black Test
Buttons 2-17 Source 2 - 17 Source 27 - 44
Button 18, 19 Bkgd 2, Bdgd1 Bkgd 2, Bdgd1
Button 20-22 ME 1A - ME 3A ME 1A - ME 3A
Button 23, 24 Shift, Shift Shift, Shift
Button 25 Delegate Delegate
Table 6. 2-ME/25 Factory Configured Source to Button Mapping 3rd and 4th Levels
Panel Button (25) 3rd 2nd
Buttons 1-17 Source 51- 69 Source 76 - 94
Button 18, 19 Bkgd 2, Bdgd1 Bkgd 2, Bdgd1
Button 20-22 ME 1A - ME 3A ME 1A - ME 3A
Button 23, 24 Shift, Shift Shift, Shift
Button 25 Delegate Delegate
Table 4. 4-ME/35 Factory Configured Source to Button Mapping 3rd and 4th Levels
Panel Button (35) 3rd 4th
To Next Page
Loading...
