140 KAYENNE — User Manual
Section 3 — System Operation
The Source ID, Source Name, and Keyer Source Rules status are displayed
in the Source buttons. Source buttons are in the source button scrolling list
(
Figure 100). Keyer source rules status is as follows:
•A=As Is
•1=On
•0=off
Figure 100. Source Ops, Source Rules Menu
Create a Source Rules Pattern
1. Touch the ME delegation buttons you wish to apply source rules to in
the left-most menu pane.
Note Multiple ME selection is supported and a Select All MEs button is provided
at the bottom of the ME selection menu pane.
2. Touch the source buttons in the scrolling source list menu pane
(multiple selection is supported), right of the ME delegation buttons,
you wish to setup as a Source Rules Pattern.
3. Touch the On, off, or As Is Source Rules state buttons in the Source Rules
Setup menu pane for each Keyer you wish to set the state.
Source
Selection
Scrolling
List
ME
Delegation
Selection
Pane
Source
Rules
Setup Pane
Source
Rules
Patterns
Pane
Store Rules
Buttons
Store Rules
Buttons
Source Buttons
with Status
Keyer Status
Buttons
To Next Page
Loading...
