GRASS VALLEY KAYENNE - V2.0 - Transitions; Manual Transitions; Transition Module

KAYENNE — User Manual 161
Transitions
Transitions
ME and Local Aux Panel transitions can be performed on the Kayenne
Control Panel. Transitions are also possible from the ME, Transition menu.
Transition Module
Manual Transitions
Manual transitions are preset with the next transition element buttons. Any
elements that are active when a transition is performed will change state.
Active keyers will transition from on-air to off-air or vice versa. Back
-
ground transitions will occur between the A and B buses with a flip flop at
the end of transition, ensuring the A bus is always on-air and the B bus is
off-air when a transition is not in progress. Any element not selected in the
next transition element group retains its current state. Combinations of ele
-
ments can be included in the same transition by selecting more than one
transition element button.
Figure 111. Transition Module
8623627_03
MMix
Transns
PVW
Transans
Rate
EMEMEMEM
Runun
Ptntn
LimLimit
Pst
BLK
KeyKey
1
KeyKey
2
KeyKey
3
KeyKey
4
KeyKey
5
KeyKey
6
KeKey1
CutCut
KeKey2
CutCut
KeKey4
CutCut
KeKey3
CutCut
KeKey6
CutCut
KeKey5
CutCut
KeKey1
AutoAuto
KeKey2
Auto
Auto
KeKey3
AutoAuto
KeKey4
AutoAuto
KeKey6
AutoAuto
CutCut AutoAuto
KeKey5
AutoAuto
Userer
5
Userer
6
Userer
4
Wipeipe
2
Wipeipe
1
Userer
3
Userer
2
Userer
1
Key
Prior
Main Transition Controls
(3 Groups and Lever Arm)
Other Transition
Controls (2)
Keyer Transition Controls
(12)
Transition
Lever Arm