180 KAYENNE — User Manual
Section 3 — System Operation
displayed on the Master E-MEM readout. When the cursor is moved from
keyframe to keyframe, the value will change to reflect the duration of the
keyframe where the cursor is located. When the cursor is moved between
keyframes, the duration shown is the distance from the current time to the
next numbered Master Timeline keyframe. The time value displayed is
used by default when a new keyframe is inserted into an effect.
Changing the Duration of a New Keyframe
The value for a new keyframe’s duration may be set from the keypad. For
example, the following procedure was used for
Figure 122.
1. Move the edit cursor to the desired location in the effect, in this case on
the path midway through a one second keyframe.
1. Press KF Duration button.
2. Type a 1.0 duration value on the keypad and press Enter to change the
value displayed on the readout.
Note Pressing Emem Edit, <enter value>, TRIM in the Master E-MEM Module will
increase or decrease the duration value by the amount specified.
3. Press Insert Before or Insert After to insert the new keyframe with the
specified duration.
Figure 122. Insert KF with Duration Specified
123 4
0.00 1.00 1.15 3.00
34 5
0.15 3.001.15 3.15
12
0.00
Insert,
With 1 Second KF Duration Entered
KF Dur 0.15
Edit Cursor On Path
0618_04_136_r0
New
Keyframe
New
Keyframe Duration 1.00
Effect Duration Increased
To Next Page
Loading...
