186 KAYENNE — User Manual
Section 3 — System Operation
to Path Hold. These path types provide fine control of the dynamics of the
effect. See
Path Control on page 77 for background information.
To Change Path Control Values in an Effect:
1. Move to the location in the effect that you wish to change.
2. Go to the Path menu (E-MEM & Timeline, Path) and delegate the desired
Level(s), Sublevel(s), and Group(s). In
Figure 126 the keyer wipe of
Keyer 1 of ME 1 has been selected for path control editing.
Figure 126. Interpolation Paths Menu
3. Choose the desired Path type (S-Linear, Linear, or Curve). If Curve is
selected, you can use the soft knobs or data pads to change the values
for
Tension, Continuity, and Bias.
4. Add the new values to a keyframe in the effect with Insert or Modify, or
Learn. You must change the keyframe, because current work buffer
values are overwritten during the running of an effect.
5. Run the effect to see your changes.
To Next Page
Loading...
