190 KAYENNE — User Manual
Section 3 — System Operation
9. Repeat the steps above for any additional background transitions.
10. Rewind and run the effect to check its operation. The transitions will
occur as programmed.
11. After the effect runs properly, you can go back and modify keyframes
with Source Holds where needed.
If unwanted background cuts occur, go to the keyframe where the cut
occurs, identify the source selected on the A bus, go to the previous key
-
frame, select that same source on the B bus, and then press Modify KF to prop-
erly setup that source in that keyframe for that next transition.
To Build Keyer E-MEM Transitions:
Individual keyers transition on or off (there is no keyer preset bus). To cross
fade between keys, use two keyers and have one key transition in while the
other transitions out. You can include any combination of keys in a single
transition, using the transition rules to determine the exact behavior of the
transitioning keys.
1. Go to the keyframe in the effect where you wish the key transition(s) to
begin.
2. Select the Key 1-6 next transition button(s) for the keyer element(s)
involved. Selected keys that are on will transition off, and keys that are
off will transition on.
3. Select the type of transition (Mix, Wipe 1, or Wipe 2).
4. Press Modify to change the keyframe to the values set above.
5. Change the on/off state of the keys you wish to transition.
6. If you are transitioning in a new key, select the source on that key bus.
If you are transitioning out a key, do NOT change the source selected
on the key bus for that keyer (this prevents an unwanted cut).
7. Press Insert After to add this keyframe to the effect.
8. Repeat the steps above for any additional keyer transitions.
9. Rewind and run the effect to check its operation. The transition(s) will
occur as programmed.
To Change the Length of an E-MEM Transition:
Change the keyframe duration of the first keyframe involved in that tran-
sition.
1. Go to the first keyframe for that transition.
2. Press KF Duration and then enter a value in <seconds • <frames> •
<fields> format on the keypad.
To Next Page
Loading...
