192 KAYENNE — User Manual
Section 3 — System Operation
on the currently selected sources, not the particular sources used when the
effect was built. Holds can be programmed into an effect with the Source
Holds menu to prevent sources from changing when that effect is recalled.
This form of hold is keyframeable, and so can be applied to specific por
-
tions of an effect.
To Set a Source Hold in a New Effect
1. Go to the Source Holds menu (E-MEM & Timeline, Source Holds).
2. Select the buses you wish to hold by touching their labeled buttons on
the menu so their green indicators illuminate (
Figure 127).
Figure 127. Source Holds Menu
3. Press LRN on the Kayenne Control Panel (Master or Local E-MEM
Module), then press a bank and register number to create a new effect
with a Source Hold in its one keyframe.
Source Hold, being a work buffer parameter, will be imposed on other key-
frames as they are inserted, unless turned off in the Source Hold menu. You
may want to start an effect with a Source Hold, so the existing sources will
not change when the effect is recalled, then turn it off to enable source
changes during the running of the remainder of the effect.
To Next Page
Loading...
