KAYENNE — User Manual 197
E-MEM Operations
2. Touch the desired macro in the menu, then touch Select to confirm your
choice or
Cancel. The name of the selected macro appears in the data
pad.
3. Select the Enable button to enable (select again to disable) that specific
macro.
4. Navigate to the desired location in the current effect.
5. Insert or Modify a keyframe to associate that macro and its enabled
state to that location in the effect.
Advanced E-MEM Operations
CAUTION Advanced E-MEM operations are recommended for very experienced opera-
tors only. Without careful planning, using these features may have unex-
pected On-Air results.
Note Define E-MEM is not keyframeable.
Partial Keyframing
Partial Keyframing is the ability to create and control independent sub-
level timelines on a keyframe by keyframe basis in an effect. A partial key
-
frame is created when any sub-level is ‘excluded’, i.e. temporarily disabled
for a level in a timeline, whether the keyframe is inserted or edited.
Partial Keyframing can include definable sub-levels as available resources
using the Define E-MEM feature which is discussed later in this section.
Note Partial Keyframing is available in the Menu Panel only.
Excluding Sub-Levels in a Level
1. Go to the E-MEM & Timeline, Recall Run menu and touch the buttons
of the switcher levels you want to enable for defining sub-levels (or
touch the
Select All toggle button. Alternatively, you can select the levels
on the Master E-MEM Module.
2. Go to the E-MEM & Timeline, Timeline Edit menu and touch the
Show Sub Levels button to the left of the level you wish to edit
(
Figure 131). The Enables menu is displayed for that level.
To Next Page
Loading...
