200 KAYENNE — User Manual
Section 3 — System Operation
Define E-MEM
Sub-levels can be made definable on an effect by effect basis to be included
in a level when an effect is recalled.
For a sub-level, there are three states possible:
• Not assigned—Not controlled by an E-MEM, for example if you want
manual control of an Aux Bus and do not want it to be recalled by an
E-MEM.
• Assigned to a E-MEM MISC Level—Under typical E-MEM control.
• Definable—Define which level will own a sub-level on an effect by
effect basis.
With Kayenne, sub-levels which are set to be defined can be ‘enabled’ in
any level.
The ten E-MEM Preferences levels’ sub-levels can be made as ‘definable’ in
the User Setups, Suite Prefs, E-MEM Prefs, menu.
To make E-MEM sub-levels definable to other levels:
1. Select an E-MEM Level.
2. Touch the sub-level you wish to make definable (Figure 133).
3. Touch the Definable button, lower right in the menu (Figure 133).
4. Repeat steps 1 and 2 for each sub-level you wish to make definable.
To Next Page
Loading...
