286 KAYENNE — User Manual
Section 3 — System Operation
Copying Between Transition and Key Wipes
If the keyer (to) is using a complex generator, you can choose which
complex wipe will be the destination. The complex wipe generator will be
copied and the keyer will be assigned to that generator. The generator is
also assigned to the transition wipe (in most cases) and the generator for
that transition wipe is also changed. If the Keyer is assigned to a keyer
wipe, only a subset of the complex wipe parameters will be assigned.
To copy a Transition Wipe to a Keyer Wipe (and Vice Versa)
1. Touch the ME and Primary (Pri Wipe 1 or Pri Wipe 2) or Secondary (Sec
Wipe 1
or Sec Wipe 2) wipe button in the From panel.
2. Turn on or off the Mattes button: On highlights green.
3. Touch an ME and Key Wipe (Key 1 - Key 4) button in the To pane, and if
desired, choose a
Preset Pattern, Inhibit Mask, or Force Mask button to copy
parameters from/to.
4. Touch the Copy button.
Copying from a Key Wipe to a Transition Wipe works the same, however
Keyer wipe values will be copied to the Transition Wipe, not the Wipe Gen
-
erator.
Copying with eDPM
eDPM Channels can be copied from one to another and between Transition
and Key Wipes. eDPM Wipes are simple wipes, similar to the Key Wipes.
To copy an eDPM Wipe
1. Touch the eDPM button in the From or To pane.
2. Touch a channel button (CH 1 - CH 4) with the parameters you wish to
copy from or to, and if desired, choose a
Preset Patt, Inhibit Mask, or Force
Mask
button to copy parameters from/to.
3. Touch the Copy button.
To Next Page
Loading...
