294 KAYENNE — User Manual
Section 3 — System Operation
Definable sub-levels can also be part of the copied register.
Copy/Swap with the Multi-Function Module
Use the Copy and Swap mode buttons in the Multi-Function Module to enter
those modes and copy or swap ME, Keyer, and e-DPM settings between
MEs (
Figure 199).
Beginning with Kayenne 2.0, the Wipe, Matt, and DPM buttons can be turned
on and off (default is on) in the MFM. With an ME and keyer selected in
either Copy or Swap menu delegations, the buttons will be available there
-
fore you can include/exclude those parameters from the copy/swap oper-
ations.
Figure 199. Copy Swap—Multi-Function Module
ME Copy/Swap
In Copy or Swap mode, the ME/Keyer/e-DPM sources are selected from
the source buttons in the top two button rows in the MFM and destinations
are selected in the bottom two rows (
Figure 199).
Note ME Keyers can be copied/swapped with e-DPM channels and vice versa.
To Copy an ME:
1. From the Home mode in the Multi-Function Module, press the Copy
button.
2. Select the Source ME/Key (Figure 199).
3. Select the Destination ME/Key (Figure 199).
Wipeipe
1
KeyKey
5
KeyKey
3
KeyKey
1
Wipeipe
2
KeyKey
6
KeyKey
4
KeyKey
2
ME1
PPK3 - Keyer
PriG SecG
K1 K5 K6K4K3
8623267_14
Copy Swap Undo
Adel Last Home
ME2 ME3 ME4 PGM eDPM
K2
ME1 PriG SecGME2 ME3 ME4 PGM eDPM
SOURCE
SOURCE
DESTIN.
DESTIN.
To Next Page
Loading...
