GRASS VALLEY KAYENNE - V2.0 - Local aux Module Device Control; Ganging

310 KAYENNE — User Manual
Section 3 — System Operation
If you have the Device Control Module option, any System Bar Device
Control Group can be associated with one of the Device Control Selection
buttons (A-F) on the Device Control Module by holding down the PREV
and NEXT buttons on a Device Control Group and then pressing one of the
Device Control Selection buttons (or vice versa as with the source select
buttons). Once the association is made, changes to the device on the Device
Control Module will be tracked on the associated Device Control Group on
the System Bar.
Local Aux Module Device Control
Ganging
The Gang Control function in the Local Aux Module allows a single point
of control for multiple devices (
Figure 206). The points of control are:
• The right-most Device Control Group on the System Bar, and
• The Device Control Module option.
Note An Aux bus link overrides a set delegate association in the System Bar.
Kayenne systems equipped and configured properly support device
control of Profile DDRs and VTRs. The Gang function permits control of
multiple external devices with the same set of panel controls. Devices can
be ganged so they play together at the same time (original and backup
tapes, for example).
Note The Kayenne Gang function does not synchronize multiple devices and there
is a possibility devices may not respond to a Play or Stop command at pre-
cisely the same time. This may cause a slight offset in playback of multiple
clips.
Figure 206. Local Aux Module
Hold
Hold
F
ar
ar
Mix
Macro
Macro
Rtr
Aux
Key
Key
Spl
Split
Tra
ns
ns
Lock
Hold
Hold
Macro
Macro
F
ar
ar
Mix W
ipe
ipe
Rtr
Aux
Key
Key
Spl
Split
Tra
ns
ns
Lock
W
ipe
ipe
3Ø
3Ø
AUX2
AUX1
2ND3RD
ME3 A
Black
ME2 A
Black
ME3 A
Black
ME2 A
Black
ME1 A
Black
Bkgd1
Bkgd2
ME1 A
Black
Bkgd1
Bkgd2
2ND3RD
353433323130292827262524232221
2827262524232221
30292827262524232221
2827262524232221
3534333231
8623267_21