KAYENNE — User Manual 311
Device Control Operations
To set up a gang for control, perform the following:
1. Press one of the Gang buttons on the Local Aux Module (right). GANG
is displayed in the top row however the button displays are blank. The
bottom row display shows sources mapped to buttons on the Local Aux
Module, in the Panel Prefs, Button Mapping menu. Buttons are colored
white and are low tally.
2. Press the source select buttons of the devices to be ganged. The source
select button for each device will change to green, high tally as they are
pressed.
The gang is dynamic so toggling sources on and off adds/removes them
from/to the gang.
3. Press the Gang button again to exit the Gang mode. The gang remains.
System Bar
Gangs can be controlled using the right-most Device Control Group on the
System Bar. Play, Cue/Load, and Previous and Next commands are all sup
-
ported (see System Bar on page 103).
Device Control Module
Panel Gangs (Local Aux Bus gangs) can also be controlled with the optional
Device Control Module. Stop, Play, Rew, Fast
Fwd, Forward Jog, Reverse
Jog, Mark, etc. are operational in Gang mode (see
Device Control Module on
page 105). Panel Gangs and the gang on the ‘F’ button (of A-F) are the same
when the SDEL button is selected. Gang device selections made in the
Device Control Module affect gang selections in the Local Aux Bus Module
and vice versa.
Multi-Function Module Device Control
The Multi-Function Module supports Single and Multiple device control.
In Single Device Control mode, you have full VTR control of an Event List
right on the Control Panel. In Multiple Device Control mode, you can select
and control up to eight devices at a time from the Control Panel, with Stop,
Cue, and Play for each (including gangs).
Single Device Control
To place the Multi-Function Module in Single Device Control mode, press
the
Devs button from the HOME position, then press the Sngl button located
below and right of the joystick (
Figure 207) on the Multi-Function Module.
To Next Page
Loading...
