316 KAYENNE — User Manual
Section 3 — System Operation
Device control includes the PLAY, CUE, and STOP command buttons, each
tally as follows:
• PLAY button high tallies green while playing and high tallies red when
on air.
• STOP button high tallies when stopped, and the
• Cue button high tallies when the current timecode for the device
matches Mark In.
Creating a Gang
To create a gang in Multiple Device Control mode, toggle any of the config-
ured device buttons (device name). Device buttons toggle between high
tally and low tally. All devices in high tally are part of the gang. Toggling
to low tally removes the device from the gang. A gang can be immediately
cancelled by pressing the soft knob (Gang Cancel), second from the top in
the Multi-Function Module.
Once a gang is created (more than one device is high tally), buttons GCUE
(Gang Cue, causes a gang to cue) and GPLAY (Gang Play, causes a gang to
play) appear below the joystick.
The first soft knob from the top controls the Auto Cancel function which
has two states,
Pressing an individual PLAY, CUE, or STOP button causes only the selected
device to respond to the command. This is beneficial for example if a
director calls for a device to be individually controlled.
GOTO Mode
Pressing the GOTO TC button on the Multi-Function Module provides dele-
gation to the Timecode Entry mode, and delegates control over the Time-
code display in the upper left of the Main function area (Figure ).
Entering the first digit causes the display to be set to zero and the first
number entered. Additional entries accumulate from right to left.
Plus (+) and minus (-) buttons are provided on the Multi-Function Module
in GOTO mode to perform trim operations.
To enter the timecode:
1. Press the GOTO button.
2. Enter the timecode using the examples below.
3. Press the ENTER button. The Multi-Function Module returns to Device
Control mode.
To Next Page
Loading...
