GRASS VALLEY KAYENNE - V2.0 - Learning Additional Devices

KAYENNE — User Manual 323
Device Control Operations
2. Press the Link Cue button (high tallies blue).
3. Learn the Q-MEM register.
4. Press the LRN button.
a. Optionally, press the Play button (flashes green) to add a play
command (so when the cue register is recalled, the clip will load and
play).
5. Press the Cue Register button to recall the cue.
Note To see the link cue status, press the lettered button then the Link Cue button.
Learning Additional Devices
You can link multiple devices in addition to the devices associated with the
lettered buttons using the Cue Device Selection menu (
Figure 212). Each
clip will need to be setup with mark-in/out points etc. prior to creating the
link.
Figure 212. DCM—Cue Links
Hold down a lettered button (A - F) and press the Link Cue button (high tallies
blue), the Cue Device Selection menu is displayed (
Figure 212). Press the
device buttons to add (or remove) devices as part of the cue then press the
ENT (or Link Cue) button. All device buttons added to the cue will tally blue.
Pressing the CLR button clears all devices from the cue.
Note Both loop cue status and link status are always learned into the cue; if the
Loop button is high tally, then a loop is learned and if Link Cue button is high
tally blue, then the multiple devices are linked into the cue.
Go To
TCTC
Mark
In
In
LinkLink
CueCue
SetSet
InIn
Mark
Out
Out
SetSet
OutOut
CueCue
Load
LoopLoop
Var
ShShutl
A B C D E F
CLR
ENT
K2-1 K2-4 K2-3 K2-2
CS-1 CS-4 CS-3 CS-2
IS 1 IS 4 IS-3 IS 2
IS 5 IS 6
8623267_34
GV/BrightStar
I
ØØ:ØØ:ØØ:22 OU ØØ:ØØ:Ø7:24
D ØØ:ØØ:Ø7:Ø2 TC ØØ:ØØ:ØØ:ØØ
CS-1
12
345
MISC4