340 KAYENNE — User Manual
Section 3 — System Operation
The Prev Page and Next Page buttons navigate through a list of available
router sources. Pressing each button advances to the previous or next
group of sources. Up to 32 router sources (24 on 2-ME systems) are avail
-
able at a time. The names of the new router sources available for selection
are shown on the middle source name displays.
The bus ID display above each upper bus button shows the router source
name for the first router source in the group. Pressing one of these buttons
directly presents that group of router sources for selection on the lower
source select bus.
Operation
Router source selection is a two step process. You first select the switcher
source you wish to change, and then select the new router source for that
destination. Router source selection may first involve accessing a page of
sources, as there may be more than 64 (48 on 2ME systems) router sources
available. Prompting in the lower left area of the panel indicates which step
should be performed next.
1. Press the Rtr button on the Local Aux Module to enter Router Assign
Mode. The source name displays will change to show only the routed
Kayenne sources, with their current router source name. All other
buttons and displays go dark.
2. Choose a switcher source by pressing its source select button. The shift
level buttons can be used to access additional switcher sources. After
selection, the source name displays will change to show the names of
the available router sources.
3. Select a router source for the chosen switcher source by pressing the
source select button displaying the name of the desired source. If there
are more router sources available, you can use the
Prev Page and
Next Page buttons to choose different groups of router sources to select
from.
4. When finished, press the Rtr button on the Local Aux Module to return
it to normal operation.
Control Panel Router Interface Operation
Controls
The Control Panel’s Source Select Modules can also be placed in an alterna-
tive Router Assign mode for changing router sources used by switcher
sources.
To Next Page
Loading...
