KAYENNE — User Manual 353
ME Split Mode Operation
Note Allocating Keyers 3, 4, and Complex Wipe Generator 2 to the Secondary par-
tition provides a logical and even division of resources. This configuration
also provides optimum Control Panel control delegations, as explained
below.
Control Panel Controls
Control Panel ME Partition Delegation
When an ME has been split, the Pri and Sec delegation buttons on that ME
are activated.
Pri and Sec Delegation Buttons
The Pri and Sec buttons delegate the source selection buses, Transition
Module, and Local E-MEM Module of that ME to the selected partition.
Pressing one of the
Pri and Sec buttons deselects the other. At least one par-
tition is always selected on a split ME.
Delegating Both Partitions
Holding down one of the Pri and Sec buttons and pressing the other dele-
gates both partitions. When the panel is delegated to both partitions, the
E-MEM and Transition Modules control both partitions simultaneously.
Also, the button tally indicators in the Transition Module and the transition
pattern shape displayed in the ME Status display reports information for
only the Primary partition.
Source Selection
When an ME is split and its Control Panel controls are delegated to only the
Secondary partition, the alternate buses for that ME are reversed. Keyer 3
and Keyer 4 sources are selected on the keyer buses and Util
1 and Util 2
sources are selected on the background buses by default. Holding down the
Alt Buses button allows source selection on the other Keyer 1, Keyer 2, Bkgd
A and Bkgd B buses. This works well for the typical situation where an ME
is split into equal partitions, with Keyer 1 and 2 assigned to the Primary
partition and Keyer 3 and 4 assigned to the Secondary partition. The ME
status display also always indicates with triangle markers the current del
-
egation for all the source selection button rows.
If both partitions are delegated, source selection behaves the same as when
only the Primary partition has been delegated.
ME Partition Preview
Preview outputs are available for both partitions of a Split ME. In Release
2.0 the
___ pvA output of each bank is used for the Primary partition pre-
To Next Page
Loading...
