KAYENNE — User Manual 365
Macros
active for macro operations. Macro names, when displayed, will also
appear on the bus row(s).
The Rec button activates or terminates macro Record mode. In this mode,
you select the macro register into which you wish to record, using the del
-
egated keyer row, perform the desired actions, and then finish the
recording by either pressing the
Rec button again or pressing the newly
recorded macro register button.
During a macro recording, time delays can be inserted into macros. The
Insert Delay button activates macro Insert Delay mode. In this mode the
macro delegated ME’s source name displays show time durations which
can be selected by pressing the corresponding keyer buttons.
The Delete button activates macro Delete mode. When delete mode is on,
pressing a macro button deletes the macro associated with that button.
When macro mode is on, pressing the Repl Attach button activates attach
mode. You then select the macro register of the desired pre-defined macro
and press the button to which you wish to attach that macro.
The Show Attach button activates a mode that low tally blinks Control Panel
buttons that have macros attached.
The Attach Enable button enables and disables all macro button attachments
globally. When on, pressing Control Panel buttons with macros attached
will run those macros. When off, macros can only be played back by acti
-
vating macro mode and pressing the macro register buttons, or with the
Macro menu.
Macro Menus
The Macro menus provide access to many, but not all, Kayenne system
macro functions. The Macro menus are useful to access and use Macro reg
-
isters not available on the Control Panel (registers 25 or 33 through 50).
Using Macros
Accessing Shifted Macros
There are four levels of macros with the Kayenne system, Shift Level 1-4.
Shift Level 1 is the default when the
Macro button is pressed on the Control
Panel, Shift Level 2 and Shift Level 3 are selected with the 2nd and 3rd
macro buttons in the Macro bus display, Shift Level 4 is accessed by
selecting both the 2nd and 3rd macro buttons on an ME bus row.
Shifted macros can also be defined and accessed from the Menu Panel, by
selecting Macros, Catalog.
To Next Page
Loading...
