368 KAYENNE — User Manual
Section 3 — System Operation
Note In Kayenne software version 2.0, macros attach to physical buttons, not the
delegated target of that button. This means, for example, if you attach a
macro to the Chroma Key button, pressing that button runs the macro
regardless of which keyer the Transition Module has been delegated to con-
trol.
To attach multiple macros to the same button, select another attach mode,
then select the macro register of the additional macro, then touch the button
to which you wish to attach it. Up to three macros (one of each type) can be
attached to the same button.
Attaching a Macro Using the Menu
1. Go to the Macros Attach menu (touch Macros, Attach) (Figure 228.
Figure 228. Macros Attach Menu
2. Select the button you wish to attach a macro to. You can either touch the
physical panel button while
Show Attach mode is active, which will scroll
to and blink that button on the Macros Attach menu, or you can use the
menu to select the panel section and then scroll the Macro Attachments
list to display the desired button.
3. Touch the Pre, Replace, or Post parameter touch button (upper right).
4. Touch the menu button for the macro register to be attached.
To Next Page
Loading...
