KAYENNE — User Manual 371
Macros
ME 1 to ME 2 and then copy ME 1 to ME 3 with a macro, include a short
delay after the ME 1 to ME 2 copy.
Macros and E-MEMs
Macros and E-MEMs can interact in two fundamentally different ways. A
Macro can be created that recalls one or more E-MEMs, or an E-MEM can
be programmed to execute one or more Macros. With care, operating both
control mechanisms together can be extremely powerful. However,
improper use can create infinite loops or other undesirable behavior. It is
especially important that your Kayenne system be loaded with the correct
E-MEMs and Macros and is operating in the correct mode, or unpredictable
system behavior will result from the mismatched E-MEMs and macros.
E-MEM Recalls in a Macro
The state of the Effects Dis and SEQ buttons are sent as part of each E-MEM
recall command. When recording E-MEM recalls to a Macro, make sure
these states are correct when you build the Macro. For example, if you want
the E-MEM effect to automatically run as a Sequence, make sure that button
is on when the E-MEM recall is recorded into the Macro.
Certain E-MEM commands that directly affect the work buffer require
special field-rate processing. This ensures all necessary processing occurs
once per field and is in sync with all the other changes occurring in that
same field. Delays are needed for multiple time cursor changes (
Next KF,
Prev KF, Begin, End, Go To KF, Go To Time, and Rewind). If you wish to use two or
more of these commands adjacent to each other in a macro, a delay of at
least one frame between them is required for consistent system behavior.
See Macros in an E-MEM on page 194 for related information.
To Next Page
Loading...
