390 KAYENNE — User Manual
Section 3 — System Operation
Touch Image Store, Replay & Record, Clip Record and Edit and touch the Build
button in the Edit Type mode button group (
Figure 242).
Figure 242. Build Edit Mode—Video Only Edit
1. Unless the desired clip is loaded, touch the Video Thumbnail Viewer
(
Figure 242).
2. Touch the Change Clip button for the Video and touch the desired clip
(
Figure 242).
3. Determine where you want a mark-in point for the Video track by
either playing/jogging to the mark while viewing the clip on a monitor
and touching the
Mark In button (Figure 242) or if you know the
timecode, touch the Mark In data pad and enter the timecode into the
pop-up keypad, and touch
Enter.
4. Determine the mark-out point for the Video track and enter it as
described for Mark In.
Mark a Thumbnail
1. Jog, shuttle, or play to where you want to mark thumbnail and touch
the
Mark Thumbnail data pad, or
2. Touch the Mark Thumbnail data pad and enter the mark-thumbnail point
in the pop-up keypad, and touch
Enter.
To Next Page
Loading...
