60 KAYENNE — User Manual
Section 2 — Concepts
Figure 34. Effect Dissolve
Note that the effect dissolve does not occur directly between two registers,
and the transition aspect is handled separately from the interpolated
parameter values. If work buffer parameter settings are changed before an
effect dissolve, the current modified work buffer values (but not the source
and button settings) will be smoothly interpolated to the new register
values.
Effect Sequence
Effect sequence allows the operator to chain a set of specified effect regis-
ters together. Recalling the first register can initiate a sequential recall of all
the registers in the sequence. As each register is recalled, its settings will be
applied to the work buffer and the appearance of the system’s output
signals will change if they are affected. Delays can be programmed that
determine when the next register in the sequence will be recalled. Effect
dissolves can also occur as each register is recalled, though this is not
required (
Figure 35).
0618_01_40_r0
Effect
Registers
New Current
Effect
Effect
Dissolve
Previous Current
Effect
Work
Buffer
0123
Effect 2
Settings
Interpolated To
Effect 3
Copy Of Work
Buffer Before
Effect Dissolve
Interpolator
Effect 3
Keyframe
Effect 2
Keyframe
99
To Next Page
Loading...
