82 KAYENNE — User Manual
Section 2 — Concepts
Figure 62. Continuity Control Setting -1.0
Bias Control
The BIAS control determines whether the path will be pulled towards the
previous or the following keyframe. With extreme settings, all of the
biasing will occur either before or after KF2. With bias set to 0 (zero), the
curve through the keyframe is gentle as shown in
Figure 63.
Note A Tension vector must be present for Bias control to be available.
Figure 63. Bias Control Setting Zero
With the bias set to 1.0, the path is pulled towards the following keyframe.
Entry into and exit from the keyframe is a straight line from the previous
Continuity = -1.0
KF1
KF2
KF3
0721_06_52_r0
+
–
Continuity
Vector
Bias = 0.0
KF1
KF2
KF3
Bias
Vector
Tension
Vector
+
-
0721_06_53_r0
To Next Page
Loading...
