96 KAYENNE — User Manual
Section 3 — System Operation
The following describes the Master E-MEM Module organization
(
Figure 74):
• Two rows of delegation buttons (left side),
• One row of Function and Mode buttons across the top (left),
• Jog Knob with LED (top right)—Rotating this knob clockwise advances
through the effect. Rotating the knob counter-clockwise moves the
effect position backwards. The degree of rotation advances the current
effect position (time) proportional to the effect duration (not to key-
frames). Two full rotations moves from one end of an effect to the other.
The status display above the Jog Knob displays the current effect’s posi-
tion (M-SS-FF).
• Below the Jog Knob (right side) is the Bar Display that also shows the
current effect position, and the
REW and Run effects buttons.
• Just left of the Bar Display is the Jog Enable button (enables the Jog
Knob) and the
Pause, Stop Next, and Rew effects function buttons,
• In the center are the Level buttons with displays. The Level buttons
have two modes:
• Enables for run control and
• Delegates for keyframe editing.
Multi-Function Module
The Multi-Function Module with positioner, delegates to the following
functions:
• Keyer Modifiers,
•Mask Modifiers,
• Matte Modifiers,
•Wipes,
•e-DPM,
•i-DPM,
• Copy/Swap utilities,
• Device control, and
• Source Selection.
To Next Page
Loading...
