112
Basic Configuration
Data Pads and Soft Knobs
that either an on or off state is typical. Yellow indicates an active function that may change
expected behavior. Red indicates an active function which significantly changes normal
behavior.
Data Pads and Soft Knobs
Data pads on the right side of the screen allow adjusting parameters with ranges of values.
Left clicking or touching a data pad opens a numeric keypad, allowing entry of a specific
value.
When equipped with a Touch Screen Menu Panel, knobs along the right side of the panel
can be used to dial in parameter values for functions displayed. When a knob is active, the
touch screen shows the parameter name and its current value on that data pad.
Menu Selection
Various GV Switcher system operating menus are selected using the menu buttons at the
bottom of the Menu panel touch screen. Menu category selection touch buttons are
directly above the Menu touch buttons. Touching one of these buttons displays that
category.
As each menu is accessed, a button for it appears in the scrolling
History pane on the left,
providing a quick return to that menu.
Favorites can also be programmed for quick access
to specific menus that are not overwritten.
Note: The optional eDPM system has its own set of operating menus,
accessed by touching the eDPM button on the lower left. For basic switcher
configuration be sure the SWR button is selected.
Power Up and Initialize the System
The Video Processor Frame, Control Panel, and menu application must be running for full
system operation.
1 Turn on the Video Processor power switch located inside the front door of the Frame,
on the front of the control board.
Label
Data Soft
Pad Knob
CAUTION: The front doors of the Video Processor Frame must remain
closed during normal system operation for proper cooling
airflow.
To Next Page
Loading...
