122
Changing the Kayenne or Karrera Menu Panel IP Address
Changing the Kayenne or Karrera Menu Panel IP Address
Set the Menu Panel IP addresses using the Windows interface. You may use the touch
screen to access the Windows settings but you will need to use a mouse and keyboard
connected to the Menu Panel for entering the IP address values. To set the Menu Panel
address:
1 Select
Eng Setup, Status, then select the Minimize Menu button. This will take you to
the Windows desktop.
2 Select
Start, Settings, Network Connection, Local Area Connection, Properties, and
follow the standard Windows IP address setting procedure.
32- Crosspoint Remote Aux Panel IP Address
The default IP addresses of Remote Aux Panels are set to at the factory before shipment will
not work with a switcher system whose other components are set to defaults. Typically,
systems are equipped with more than one Remote Aux Panel. If more than one Remote Aux
Panel will be used on your system, you will need to change each panels’ IP addresses so
none are duplicated, and this must be done before you connect them to the network. This
will require a mouse and keyboard connected to a PC disconnected from the network.
Check with your network administrator to learn what IP addresses should be used at your
facility.
Setting the IP Address
A PC equipped with an Ethernet interface and a web browser is required to change Remote
Aux Panel IP addresses.
1 W
ith the PC disconnected from all facility networks, connect the PC’s Ethernet port
directly to the Remote Aux Panel.
Note: A crossover Ethernet cable (Tx/Rx pair crossed) is needed when
connecting a PC directly to the Remote Aux Panel without a hub
intermediary.
To Next Page
Loading...
