GRASS VALLEY KAYENNE - Configure the IP I;O IP Address and Ports

Installation & Service Manual
141
Local IP Addresses
The Local IP Address is used for two purposes:
• To transmit the Local IP Address from the switcher system so other devices can identify
where data is being transmitted from, and
• As the Receive IP Address so devices can send data to the switcher system.
Receive IP Addresses and UDP Ports
For the Receive IP address channels, you can either use the default presets or change them
to fit your preferences, including the Local IP. The default port setting for Receive IP is N/A.
The N/A setting means signals from an IP address with any port setting is available to the
configured device. Setting the UDP Port number allows you to filter signals, for example
signals from two or more channels using the same IP address.
Configure the IP I/O IP Address and Ports
Configure IP I/O Transmit IP Addresses and UDP Ports
To transmit a video signal from a Switcher IP I/O Module channel, the Transmit IP address
must be set; the factory default is 0.0.0.0. The default port assignment is 1000.
1 In the Eng Setup, Video I/O, Modular IP Config switcher menu tab, select the Transmit IP
Address data pad for the IP I/O channel, enter the IP address in the pop-up keypad, and
select
Enter.
2 To set the Transmit IP UDP Port, select the data pad for the channel, enter a port
number, and select
Enter.
3 Se
lect the Apply Settings button.
Configure IP I/O Receive IP Addresses and UDP Ports
To receive signals over IP, you must set the Local IP address so the signal is available to your
device. For the Receive IP address channels, you can either use the factory presets or
change them to fit your preferences, including the Local IP. The default port setting for
Receive IP is N/A (see Receive IP Addresses and UDP Ports)
1 In the Eng Setup, Video I/O, Modular IP Config switcher menu tab, select the Local IP
data pad for the I/O IP channel you wish to configure, enter the IP address for your
device, and select
Enter.
2 Select the Receive IP Address data pad for the Modular I/O IP channel, enter the IP
address in the pop-up keypad or select dot (.) to select the Local IP address, and select
Enter.
3 To set the Receive IP UDP Port, select the UDP Port data pad for the channel, enter a
port number, and select
Enter.
4 Select the
Apply Settings button.