Basic Configuration
178
Create an On Air Relay Tally Calculator Using Aux Buses
1 If necessary, login to the desired suite (Eng Setup, Eng Login).
2 Select
Eng Setup, Switcher Tally, On Air Tally to access the On Air Tally menu. The Suite
button for the current suite will be highlighted.
3 Select a
Tributary button on the right.
4 Select the
Aux button on the left.
5 Select Aux bus button(s) to assign that output of that Aux bus to that tributary. The
name of the output is displayed on the
Tributary button.
6 Repeat the steps above for other Tributaries for all the outputs you wish to assign for
On Air Tally.
• Pressing the
None button clears the assignment for that Tributary.
• Pressing the Reset button clears all the assignments to all the Tributaries.
Creating a Look Ahead Relay Tally Calculator
1 Select Eng Setup, Switcher Tally, Tally Calc 1-4 to access a Tally Calc menu.
2 Select the
Calc 1-4 Name button to open a keypad you can use to name that calculator.
3 Select a Suite 1 - Suite 4 button for the GV K-Frame XP suite that will use this calculator.
4 Select a Tributary button on the right.
5 Select an
ME or PGM/PST button on the left.
6 Select a LAP 1-4 button to assign that look ahead to that Tributary.
7 Repeat to assign all the desired look ahead previews to the calculation.
8 To activate this calculator, touch the
Calc On button so it is highlighted.
To Next Page
Loading...
