GRASS VALLEY KAYENNE - Clipstore Configuration; Summit;Solo Software Version; Setting the Summit IP Address; Install the Clipstore License

Installation & Service Manual
185
ClipStore Configuration
ClipStore Configuration
ClipStore basic configuration includes preparing the Summit/Solo and GV K-Frame XP
systems through licensing, IP addressing, software installation, cabling, and GV Switcher
menu configurations.
Summit/Solo Software Version
The latest version of the ClipStore server software is available on the Grass Valley Switcher
Software Download site.
For more information about installing and updating AppCenter Elite software, see the
Summit/Solo manuals.
Setting the Summit IP Address
The ClipStore Summit/Solo server is shipped with the following defaults:
• IP Address: 192.168.0.180
• Mask: 255.255.255.0
• Gateway: 192.168.0.1
• WINS: disabled (0.0.0.0)
• DNS: disabled (0.0.0.0)
You can temporarily change the default settings using Netconfig (see the NetConfig
Network Configuration Application Instruction Manual at www.grassvalley.com).
The NetConfig Network Configuration Tool can be installed with the K-Frame Switcher
Installer software.
IMPORTANT: Make note of the ClipStore IP Address, it will be used later
to enable ClipStores as external devices in the configuration process.
Install the ClipStore License
Verify that the GV Switcher software is version 15.0 or later. For information about
upgrading software, see the Kayenne/Karrera/GV Korona Release Notes.
Install the ClipStore license. The following are the ClipStore options:
• K
RR-CLPS-2CH-PAK (2-Channel Solo Server Platform)
CAUTION: Do not use AppCenter Elite software for ClipStore from the
Summit/Solo server web site as it might not be compatible.