Installation & Service Manual
189
ClipStore Config Menu
ClipStore Config Menu
The ClipStore Config menu is used to configure the ClipStore input/output parameters and
read those input/output parameters from, or send them to, the ClipStore server.
u
Read from ClipStore button—Updates the Eng Setup, ClipStore Config menu with the
current parameter settings for the configured ClipStore server channels.
Send to ClipStore button—Sends all parameter and system settings required by ClipStore
to record, edit, and control clips to the server. Any changes to the Record Setup or Replay
Setup parameter settings will also be sent to the ClipStore server. A dialog is displayed
when this button is pressed, stating that all clips will be ejected as part of this operation;
keep this in mind if considering this operation during a broadcast.
The ClipStore Source Numbers Pane (read-only), provides channel and source information,
for example CS-1025 means ClipStore Channel1 (CS-1), Eng Source ID 25 (025).
Bars and Tone button—Turning this button on (highlighted green) then selecting the Send
to ClipStore
button, loads color bars (and updates the configuration) and sends a tone to
the selected ClipStore channel for testing.
To Next Page
Loading...
