GRASS VALLEY KAYENNE - Define Default Multi-Suite Engineering Resources; Acquire Resources in Suites

Installation & Service Manual
213
communications. After restart, the Eng Setup, Status Menu will display the added
control surface.
Result: Only the specified PCU ports will operate with the control surface Stripes in
each suite.
Note: For Kayenne Control Panels, the Multi-Function Module only reports
the Prime IP address (Home, Panl, IP), even if an Alternate IP Address is
configured.
Define Default Multi-Suite Engineering Resources
Assign the following items as appropriate to each suite:
• Outputs (Pgm, Switched Preview, Aux Buses, etc. accessed via Eng Setup, Outputs).
Each suite has its own, logical set of outputs that are identically numbered. Use the
Suite 1
through Suite 4 buttons to assign them to a suite.
• GPI Outputs (
Eng Setup, Acquire Resources, GPI Outputs).
• Editor Port, if used, are permanently assigned for use by each suite (
Eng Setup, Ports &
Devices, Editor Port
).
• Switcher Tally (Eng Setup, Switcher Tally).
Note: Each suite has its own logical set of outputs that are identically
numbered. Use the Suite 1 through Suite 4 buttons to assign them to a suite.
Acquire Resources in Suites
Note: Changes to Suites and Resource acquisition can have serious switcher
system operation impacts that might not be completely obvious. For this
reason, precautionary dialogs requiring a response will be displayed.
Resources are released from one suite then acquired in another. Suite 1 is configured as the
default suite.
1 Se
lect Eng Setup, Eng Login and answer Yes to the warning message, and login to a
suite using the
Change Identity button.