Installation & Service Manual
217
To access a different Suite or Control Surface (CS):
1 Select
Eng Setup, Eng Login.
2 Select the Change Identity button. The Suite and CS buttons will then be available for
selection. After selecting a different button, a warning message appears.
3 Select
Yes to make the change, or No to cancel the change and retain the existing
menu identity.
Note: Changing a menu’s identity in this way is temporary. Reloading the
menu application or rebooting the Menu Panel will restore the Suite and
Control Surface identity defined in the Node Settings, Control Surfaces
menu.
System resources can be allocated to each suite. By default, all system resources are
allocated to Suite 1.
MatchDef and SetDef
The MatchDef and SetDef options permit line rate signal format conversion of system
outputs and inputs. MatchDef input and SetDef output conversion is licensed in groups of
four. Connectors are active when the associated Conversion I/O board is present and the
license is enabled. Selecting a Modular I/O button, labeled M1, M2, etc., displays controls for
either input or output conversion in the right-hand pane.
To Next Page
Loading...
