GRASS VALLEY KAYENNE - Karrera Control Panel Adjustments; Lever Arm Calibration

Installation & Service Manual
291
Button Hold Down for M/E Stripe Mapping
On the M/E Stripe you wish to remap, press a Key 1 through Key 6 button on the Transition
Module in that Stripe to choose a PCU port for that Stripe. If that PCU port is used by
another Stripe, it will be swapped.
When the Stripes are remapped, press the button labeled EXIT (
Key Prior). The display
informs you that mapping changes take place after reboot, and a with a Reboot Now
prompt appears. Pressing the button labeled YES will reboot the Panel.
Karrera Control Panel Adjustments
Lever Arm Calibration
1 In any E-MEM area, press Menu, Page. This shows a list of menu items that are selected
with the buttons below the display (on the left).
Karrera Calibration Menu, E-MEM Area
2 Select Calib (press 7) to enter calibration mode (on the right).
Note: Pressing the Menu button at this time exits calibration mode without
making any changes.
USE K1 THRU K4 BUTTONS
TO
SET ME STRIPE NUMBER.
STRIPE 1 IS TOP OF PANEL
Ptn
EMEM
Run
Rate
Cut Auto
ME STRIPE=1 PCU PORT=1
Cut
Cut
Key
Prior
1
Cut Auto
User User User
1 2 3
PVW
Cut Auto
Wipe Wipe User
1
2 4 5
Pst
Cut Auto
1.
8623266_70
Menu 1
Macro
Panel Stripe
Mem Delg
Trans
Rate
Menu 2
IP
Addr
Calib Time Date
Panel
Saver