Installation & Service Manual
303
at midnight, but do not immediately go into effect. Instead, any expired options continue
to operate until the system is power cycled or reset, at which time the options are disabled.
This is intended to prevent loss of functionality during on-air operations. Expiration of the
maintenance portion of an authorization will not disable any options.
Authorization Procedure
Acquire Authorization Code
Grass Valley will be sending authorization codes to all GV K-Frame XP system customers. If
you have received your codes and the system IDs are correct, proceed to Enter Permanent
Authorization Code. If you do not have valid authorization codes you will need to acquire
them from the Grass Valley.
1 Go to the Install Options menu by touching
Eng Setup, Install Options.
2 Write down the System ID displayed on the upper left portion of the menu.
3 If you have more than one system, repeat the above steps on every system that will
have options enabled.
4 Contact Grass Valley Customer Support and request a code for each GV Switcher
System ID. If options have not already been purchased, you can order the options
directly from the service representative.
To Next Page
Loading...
