GRASS VALLEY KAYENNE - Assign Sources

Kayenne/Karrera/GV Korona
User Manual
119
The example shows the two defined eDPM sub-levels in the Master E-MEM Timeline for
M/E-3.
Using definable sub-Levels allows for the recall of eDPM effects from Local E-MEM. For
example, effects created for M/E 1 can have the eDPM definable sub-levels and will then
run eDPM effects.
Assign Sources
Assigning sources for eDPM transform is done in the eDPM Mode Source Ops, eDPM menu.
To assign sources in the eDPM Mode Source Ops, eDPM menu (also available in the
Switcher Source Ops menu):
1 In the menu, select
Source Ops, eDPM.
2 Select the input channel button for the channel you wish to assign a source.
3 Scroll and select the source you wish to assign to the eDPM channel from the Sources
scrolling list (right side of menu).
Note: If you select an eDPM Fill button first, then a source, the Cut and
Fill signal for that channel will be the same. Select the Cut button to
assign a different source for the Cut button (split key).
4 Repeat Steps 1 and 2 for up to four input sources for each eDPM channel.
eDPM Definable
Sub
-levels