Video Mix/Effects
Button Mapping eDPMs to an M/E
120
Button Mapping eDPMs to an M/E
Map the eDPM outputs to the source select buttons on the M/Es in the User Setups, Panel
Prefs, Button Mapping menu (see Map Control Panel Source Select Buttons, on page 35).
Note: eDPM sources are identified as eDA and eDC and have a
corresponding key (cut) signal already associated with those outputs,
therefore the key signal outputs of the eDPM channels do not need to be
mapped on the switcher for normal operations.
eDPM Mode Menus
Selecting the eDPM Mode button (bottom left) changes the menu to the eDPM Mode.
eDPM 2DPM Menu
When the 2D DPMs option is enabled, the eDPM Transform menu’s Channel 2DPM tab will
be active.
Enabling eDPM 2D DPMs
1 Select eDPM, Transform.
2 Select the Channel 2DPM tab.
3 Double click on an eDPM channel to enable 2D DPM on that channel.
eDPM Effects Menus
The eDPM, Transform menu is identical to the iDPM, Transform menu (DPM Transform
Menu, on page 96) in all ways except the ME/Keyer selection matrix (upper left pane) is
replaced with the six channels of the eDPM, however the functionality is the same in regard
to selecting channels and Global Channels.
The remainder of the eDPM effects menus operate the same as in the iDPM menu:
• Transform (Transform Controls, on page 99
)
• B
order (Border Menu, on page 100)
• Borderline (DPM Borderline Menu, on page 100),
• Film Look (iDPM/2D DPM Film Look Menus, on page 103),
• Kurl (iDPM Kurl Menu, on page 103),
• Splits & Mirrors (DPM Splits Mirrors Menu, on page 107),
• Defocus (DPM Defocus Menu, on page 107)
• Lighting (DPM Lighting Menu, on page 108), and
• Output Recursives (Output Recursive Menu, on page 110).
eDPM Category Menus
The eDPM Mode category menus for the GV Switcher eDPM option operate independently
from the Switcher Mode (there is access to eDPM menus in the Switcher Mode for
convenience).
To Next Page
Loading...
