Kayenne/Karrera/GV Korona
User Manual
127
3 Enter the target register number for the E-MEM you wish to put the current register’s
E-MEM Timeline information, and press
ENT/Enter.
Note: Pressing the Put button then the Dot “.” button will put the current
register into the next available register.
Perform a Get
The Get function allows you to copy the E-MEM Timeline information from another E-MEM
register to the current E-MEM register.
1 Press the
EMEM Edit button on the Master E-MEM Module.
2 Press the
Get button, the Get Register menu is displayed.
3 Enter the target register number for the E-MEM you wish to get the E-MEM Timeline
information from, and press ENT/Enter).
Note: Pressing the Get button, Dot “.” button, then ENT/Enter clears the
current register. The Master E-MEM Module displays a “Clear current?”
prompt after pressing the Get and Dot “.” buttons. Press the ENT/Enter
button should you wish to continue.
Recalling E-MEM Registers from the Control Panel
If recalling effects from the Master E-MEM area with Auto Recall off, you first need to specify
which levels you wish to control with the Enable buttons in the E-MEM & Timeline, Register
Ops menu.
To recall an E-MEM register, press the following:
1
Page button (if necessary).
2 Button for the desired page: 0, 100-900.
3
BNK/Bank button.
4 B
utton of the desired bank.
5 Keypad button of the desired E-MEM register.
Alternatively, you can perform the Bank, then Page selections, then press the desired
register button.
GV Korona E-MEM Run from the Control Panel
A Local/Master E-MEM Run button (L-Run/M-Run) is available on the GV Korona Control
Panel. When the top Source Select button row is delegated to E-MEM (by pressing the
E-MEM delegation button) the right-most Source Select button is delegated as a Run
button.
To Next Page
Loading...
