Kayenne/Karrera/GV Korona
User Manual
131
Figure: Local E-MEM, ME3, Register 732 recalled in Standard Mode (Page, Bank, Register)
In the above, the panel is configured with the E-MEM Numeric Operations Enable off. This means that it will
use the normal Page, Bank, Register method to recall an E-MEM register as described here. The above the user
has recalled or learned E-MEM register 732 and so the numeric buttons:
1. Are Orange to show that ME3 is the stripe delegation
2. Buttons 2 and BNK3 are high tally to show they are the current selection
Within the top status line of LEDs the numbers 7 and 3 at the left indicate that Page 7 (700) and Bank 3 (30) are
current, with the number 732 showing the currently recalled register, the current keyframe and a space for the
name of the register.
The status display shows a number for the keyframe other than zero if the E-MEM exists (i.e. 0 means that the
register is empty.)
The standard Page, Bank, Register method sets a register number using the control panel E-MEM areas like this:
1. Press “Page” – select a number between 0 and 9
2. Either press “Bank” at bottom left – select a number between 0 and 9
3. OR Press or double press one of the BNK buttons at the right to access Banks 0-7
4. Having selected Page and Bank press a register number between 0 and 9
If Page and Bank do not need to be changed pressing a numbered button between 0 and 9 causes an instant
recall of the E-MEM register.
The rules for learning are conditional on the state of partial keyframe setup and explained in the Advanced
Operations section of this Manual.
To Next Page
Loading...
