GRASS VALLEY KAYENNE - Recall a Macro Register from the Master E-MEM; Pre-Attach a Macro; Post-Attach a Macro; Attach Multiple Macros to the same Button

Kayenne/Karrera/GV Korona
User Manual
147
Note: Stopped macros tally the macro color, running macros tally
orange. Pressing a button with a running macro delegated or attached,
stops the macro (pressing it again starts the macro from the beginning).
Recall a Macro Register from the Master E-MEM
In the Master E-MEM area, press Menu, Macro (Lrn/CWB) select a register page button
1 Turn on Macro mode with the Macro button (f not already on, you may also want to
press the Show (Attach) button to display the macro names on the source name
displays).
2 Select the macro to be played
• On the Control Panel, press the keyer button of the desired macro register. The
Shift button accesses shifted macros (2nd, 3rd, and 4th).
• From the Macro menu, select the Macro register button of the desired macro
register, then select the
Play button.
Pre-Attach a Macro
1 Delegate the bus rows to Macro by pressing the Macro button on the Control Panel.
2 Press and hold down a macro button for attachment in the Macro row.
3 Press a Control Panel button to which the macro will be attached (if
Show (Attach) is on,
the panel button will flash.
Post-Attach a Macro
1 Delegate the bus rows to Macro by pressing the Macro button on the Control Panel.
2 Press and hold down a Control Panel button for the attachment.
3 Press the macro button to be attached in the Macro row (if Show (Attach) is on, the
newly defined macro button will flash until Show is turned off).
Note: Macros attach to physical buttons, not to the delegated target of
that button. This means, for example, if you attach a macro to the Chroma
Key button, pressing that button runs the macro regardless of which
keyer the Transition area has been delegated to control.
Attach Multiple Macros to the Same Button
Up to three macros (one of each type) can be attached to the same button.
1 Select an attach mode.
2 Select the macro register of the additional macro.
3 Press the button to which you wish to attach the additional macro.
Remove a Macro Attachment
1 Press the Delete button on the System Bar.