GRASS VALLEY KAYENNE - Record a Macro; Insert a Macro Delay; Insert a Macro User Pause

Kayenne/Karrera/GV Korona
User Manual
149
The Record button activates or terminates macro Record mode (Stop Record). In this mode,
you select the macro register into which you wish to record, using the delegated keyer row,
perform the desired actions, and then finish the recording by either pressing the
Stop
Record
or pressing the newly recorded macro register button.
The
Append Macro button allows you to append actions to an existing macro.
Record a Macro
Master E-MEM
1 In the Master E-MEM area located top right of the Control Panel, press the Page button
to see the Macro option. Press the button under the Macro label to display the Macro
registers and controls.
2 Touch the
MAC button in the Status Display.
3 Touch the Record button.
4 Press a Macro register button in the Master E-MEM; the button flashes indicating the
macro is recording.
5 Perform the steps you wish to record using the Control Panel and/or the menus.
6 Complete the recording by either selecting
Stop Record in the Status Display or by
pressing the Macro register button again.
Macro Delegated Row Buttons
1 Press the Macro button in the Delegation area located above the Source Select area of
a Stripe; the button row above the OLEDs is now delegated to Macro.
2 Pre
ss the Macro button with which you want to associate the recorded macro.
3 Touch Record in the Status Display.
4 Perform the steps you wish to record using the Control Panel and/or the menus.
5 Complete the recording by either selecting
Stop Record in the Status Display or by
pressing the Macro button again.
Insert a Macro Delay
While recording a macro, press the Ins Delay button then press the keyer source select
button of the desired delay time. The 2nd Shift button (3rd and 4th are undefined for this
function) splits the time interval selection between fields (upper key row) and seconds
(lower key row). Multiple selections can be made to insert longer delays in both fields and
seconds.
Insert a Macro User Pause
1 Touch the MAC button in the Transition area status display.
2 Touch Record.
3 Press the Macro button in the Delegation row (above the OLEDs and top button row) of
the Source Select area to delegate the button row.
4 Press a macro delegated button to start recording.