GRASS VALLEY KAYENNE - Attaching a Macro; Playing an Attached Macro; Appending to a Macro

Switcher Control
Learn a Select E-MEM Command
158
Attaching a Macro
1 Select Macros, Attach.
2 Select the button you wish to attach a macro to. You can either select the physical
panel button while
Show Attach mode is active, which will scroll to and blink that
button on the Macros Attach menu, or you can use the menu to select the panel
section and then scroll the Macro Attachments list to display the desired button.
3 Select the
Pre, Replace, or Post parameter select button (upper right).
4 Select the menu button for the macro register to be attached.
5 If desired, name the macro by selecting the Name data pad and entering the name in
the pop-up keyboard. Press
Enter.
Playing an Attached Macro
1 Turn on the attachment playback feature by pressing the Attach Enable button so it is
illuminated. You may also want to press the
Show Attach button so that panel buttons
with macros attached can be identified (they blink low tally).
2 Press the panel button that has the macro attached.
Appending to a Macro
1 Select Macro, Catalog in the menu.
2 Select the Macro Register number button of the register you wish to record additional
steps into.