GRASS VALLEY KAYENNE - Change Background Buses with Panel Mems; Source Rules

Kayenne/Karrera/GV Korona
User Manual
167
2 Assign the Delegate button from the menu.
a Select Panel Prefs, Button Mapping in the menu.
b Select a button to assign the Delegate.
c Select the Delegate button.
Change Background Buses with Panel Mems
Delegate buttons do not have to be assigned to the Source Select Module in order to
change the Background bus row delegations (A/C, B/D). Once delegated, Panel Mems will
include the Primary and Secondary Background bus row settings and can be recalled to
change the Background bus delegations. The Background row Delegation buttons can then
be used for sources or other assignments, see Map Control Panel Source Select Buttons, on
page 35.
Source Rules
Source Rules allow the user to associate Keyer states with sources. As a user cuts on the A
Bus of an M/E, Keyers will be switched on/off or the state is maintained, depending on the
source selected. In addition, sources selected on the B Bus (Preset) will affect the settings of
the Next Transition buttons on the Transition Module which will be set up so that the
desired Keyer status will result after the transition is performed. No user intervention is
required, because Source Rules will have been applied logically. However, Source Rules are
applied as sources are selected on the A or B Bus so it is possible to override or change the
Next Transition settings in the Transition Module prior to the Next Transition.
For example, Source Rules may be set for studio cameras to ensure the station logo (bug) is
always visible when On-Air, and a different logo is used with a helicopter camera when the
“Heli-Cam” is cut to air. Should the director call to keep the studio camera logo over the
helicopter, the operator can preset the Heli-Cam and then adjust the Next Transition
buttons on the required effect.
Source Rules force keyers to be in one of three states: On, off, or As Is (the default), on a
source by source basis. A pattern of Source Rules for selected sources can be setup, applied,
named, and stored for later use.
Source R
ules are saved as part of a Show file (unless deselected).
The Source ID, Source Name, and Keyer Source Rules status are displayed in the Source
buttons. Source buttons are in the source button scrolling list. Keyer source rules status is as
follows:
• A=As Is
• 1=On
• 0=off