GRASS VALLEY KAYENNE - Configuring a Source Table with Source Substitutions; Storing (Copying) Source Table Substitutions to Another Source Table

Switcher Control
Bus Linking Source Substitution Tables
172
Configuring a Source Table with Source Substitutions
The default is one-to-one, i.e. Source 1, Linked Source 1, Source 2, Linked Source 2, etc. You
can substitute the current Linked Source (Linked Source column) with any source from the
scrolling Source List.
1 Select a source table in the Source Tables list.
2 Rename the Source Table (recommended) by selecting a Source Table data pad,
selecting the Rename button, and entering a new name.
3 Select a source in the Linked Source column of the Source/Link Source scrolling list the
Table Setup pane.
4 Select the substitute source in the scrolling Source List.
5 Repeat the first two steps for all source substitutions.
Storing (Copying) Source Table Substitutions to another Source Table
Source Table configurations from one source table can be stored (copied) to another using
the Store button.