Kayenne/Karrera/GV Korona
User Manual
177
• If the Linked bus is in video-video mode, a B side source change from the Controlling
bus will change the Linked bus's B side.
Note: A video-only bus behaves as if it is the A side of a bus pair.
Bus Linking Management
Individual bus links are enabled and disabled with the Link Enable button in the Controlling
bus pane. When enabled, commands will be sent from the Controlling bus to the Linked
bus, provided all links are not inhibited (see below). Link Enable is keyframeable.
Other controls on this menu can be used to manage bus links.
Bus Hold Inhibits Links – This control affects the behavior of the Control Panel Hold button
for all Linked buses. When Bus Hold Inhibits Links is On and the Hold button on a Linked
bus is also On, that Linked bus will ignore bus link commands and will not change sources
when Controlling bus sources change. Note that the Hold button retains its existing
functionality, keeping that bus from changing sources when an E-MEM register is recalled.
Inhibit All Links – Overrides all Link Enable settings to disable all active bus links. This does
not change the individual Link Enable settings, however. Turning Disable All Links off will
re-enable any bus links with Link Enable on.
To Next Page
Loading...
