GRASS VALLEY KAYENNE - Module Overview; Transition Module

Switching Basics
Setting Panel Saver Mode
180
Spllit
U 1 U 2
BLK
Cutt
Auto
Ptn
Module Overview
An M/E Stripe has a module for source selection, transition, and individual E-MEM control.
Additional Master E-MEM, Device Control (optional), Multi-Function, and Local Aux
modules are populated to complete the control surface functionality. System operation
information and procedures will be covered more thoroughly later in this chapter.
Source Module (35, 25, or 15)
Portion of Control Panel M/E Stripe
Transition Module
Transition Module Local E-MEM Module
The Transition Module is organized into two control groups, the main transition controls,
with status display and transition lever arm, and keyer transition controls. For information
about using transitions, see Transitions, on page 207.
Main Transition controls:
• Lever Arm—For manual transitions
• Status Display—Displays bus and keyer delegation and status
• Next Transition Element buttons
• Next Transition Type buttons
• Cut/Auto Transition buttons with Trans Rate display
• Transition Preview and Preset Black buttons
Keyer transition controls:
• K1-K6 (Keyer) Cut buttons
• K1-K6 Auto Transition buttons
8874_01
Key
2
Key
4
K ee
y
6
Rtr
K ee y 1
Cutt
Ke y 1
Autto
Ke y 2
C uut t
Ke y 2
Autto
K ee y 3
C uut t
Ke y 3
Autto
S e cc
R uu l e ss
H o l dd
Ke y 5
C uut t
Ke
y 5
Autto
K ee y 6
Cutt
Ke y 6
Autto