Switching Basics
Source Select Module
186
Master E-MEM Module Example
The following describes the Master E-MEM Module organization:
• Two rows of delegation buttons (left side),
• One row of Function and Mode buttons across the top (left),
• Jog Knob with LED (top right)—Rotating this knob clockwise advances through the
effect. Rotating the knob counter-clockwise moves the effect position backwards. The
degree of rotation advances the current effect position (time) proportional to the effect
duration (not to keyframes). Two full rotations moves from one end of an effect to the
other. The status display above the Jog Knob displays the current effect’s position (M-
SS-FF).
• Below the Jog Knob (right side) is the Bar Display that also shows the current effect
position, and the REW and Run effects buttons.
• Just left of the Bar Display is the Jog Enable button (enables the Jog Knob) and the
Pause, Stop Next, and Rew effects function buttons,
• In the center are the Level buttons with displays. The Level buttons have two modes:
• Enables for run control and
• Delegates for keyframe editing.
Multi-Function Module
The Multi-Function Module with positioner, delegates to the following functions:
• Keyer Modifiers,
• Mask Modifiers,
• Matte Modifiers,
• Wipes,
• e-DPM,
• i-DPM,
• Copy/Swap utilities,
• Device control, and
EMEM
MSC1 MSC5 PART IS-1 IS-2 LRN 7
MSC2 MSC6 AUX IS-3 IS-4 SEQ 4
MSC3 MSC7 GPI IS-5 IS-6
DIS 1
MSC4 MSC8 PBUS EXT PAGE BNK . 0
BNK0
To Next Page
Loading...
