Switching Basics
Perform a Mix Through Video Transition
212
For any wipe pattern, position, rotation, and size for a preset pattern or transition
percentage for a transition can interact and sometimes have an unexpected appearance.
Therefore, it is important to preview the settings for a wipe before taking it on-air. If the
preview of the wipe settings shows the desired behavior, the wipe will consistently perform
as expected with those settings.
Note: Horizontal and Vertical Modulation will work if the keyer is
contained to one quadrant of video.
Most wipe patterns available in the HD modes are available in 4K mode.
Note: Unsupported wipe pattern buttons are not grayed out in the GV
switcher menu in 4K Mode.
Kayenne Transition Module
Kayenne Manual Transitions
Manual transitions are preset with the next transition element buttons. Any elements that
are active when a transition is performed will change state. Active keyers will transition
from on-air to off-air or vice versa. Background transitions will occur between the A and B
buses with a flip flop at the end of transition, ensuring the A bus is always on-air and the B
bus is off-air when a transition is not in progress. Any element not selected in the next
transition element group retains its current state. Combinations of elements can be
included in the same transition by selecting more than one transition element button.
To Next Page
Loading...
