Kayenne/Karrera/GV Korona
User Manual
213
Transition Module
Perform a Lever Arm Transition
1 Select the next transition button(s) for the element(s) involved (Bkgd, Key 1,2,etc., Key
Prior
). Selecting one element button disables any others selected. Holding down one
button while pressing another selects both elements, allowing all the transition
elements to be activated if desired.
2 Select the type of transition (
Mix, Wipe 1/Wipe 2, or User Transitions).
3 Select any new sources involved in the transition:
• If performing a background transition, select the new source to transition to on the B
bus.
• If you are transitioning in a new key, select that new source on the key bus.
• If you are changing key priority, specify a new key priority in the Keyer Priority menu.
4 If desired, select a transition modifier (Trans PVW or Preset Black).
5 Move the transition lever arm. The picture will transition only the elements selected.
Other elements will remain unchanged.
Perform an Auto Transition
1 Setup for an Auto Transition is the same as a lever arm transition (Perform a Lever Arm
Transition, on page 209) with the following added step:
2 Specify the duration of the transition by turning on the
Trans Rate button, selecting the
flashing button of the desired element, and entering a value in <seconds> • <frames> •
<field> f
ormat (Time Value Entry, on page 125). Different durations can be specified by
repeating this process for each element.
3 Press the
Auto Trans button. The picture will transition only the elements selected at
the specified rate(s). Other elements will remain unchanged.
To Next Page
Loading...
