Device Control
Enables Menu
220
Enables Menu
Generally, properly configured external devices are connected by default (green status bar).
Enabling and Disabling Devices (Troubleshooting)
If devices lose communication (red status bar), you can try enabling the device(s) (Enable
Selected/Enable ALL buttons) to reestablish communication or if devices are purposely off-
line, they can be disabled to prevent the menu from displaying error messages. Devices
must be disabled, either by selecting the Disable Selected or Disable ALL buttons or from a
loss of communication before they can be enabled.
Note: ClipStore devices are enabled/disabled in the Eng Setup, Node
Settings menu only.
Timeline Events Menu
The Timeline Events menu allows you to learn selected external device control commands
along an E-MEM timeline (see Control an External Device Using Timeline Events and E-MEM,
on page 228). The controls change based on the type of device selected.
To Next Page
Loading...
